/  Primeline Products   /  What is Different Methods of Sewer Pipe Relining in Altamonte Springs?

Most people assume that a cracked pipe means that it will have to be replaced. However, this isn’t always the case. In many instances, you can actually replace the lining.This is especially helpful for those who would like to preserve the area around the pipe. By replacing the pipe you completely avoid all of the collateral damage that tends to come along with the excavation of sewer lines that are positioned beneath sidewalks, landscaping, trees and driveways. And the great thing about relining a pipe is that there a number of options to choose from. So, what are the different methods of sewer pipe relining in Altamonte Springs? Let’s discuss four of the most popular.

Pipe Bursting

If your pipe has suffered severe damage, then professionals may suggest pipe bursting. During this particular process, an individual will repair large sections of your pipeline or replace your entire system altogether. You see, in order to repair your pipe, professionals will have to gain access through two square, 4-foot access pits at either end of your pipeline. The installers will then place a bursting head at the access point of your pipe. After that, they will use hydraulic power in order to drag the head through your pipe and as it moves through the system it will break your old pipe apart and draw in a new seamless one. And the great thing is since the pipe is plastic, you won’t have to worry about root intrusion for 100 years. Even though replacement is involved, this form of relining is still less intrusive than excavation.

Pipe Coating

If you have noticed that existing sewer pipes are starting to leak into the areas that surround your soil, then it’s very likely that installers will use pipe coating in order to repair the damage. First, they will completely drain the pipes of water. Then they will spray a thick coating of epoxy around the inside of the pipes. This method helps to permanently seal all of the cracks throughout your entire pipeline.

Cured-in Place

Curing the pipe in place is one of the most common methods used in trenchless repair. In fact, there are a lot of sewer companies that can repair a crack in the pipe without having to ever dig a trench, How, you ask? Well, it’s all done remotely. First, they clean and dry the interior of the pipe. They will then apply lining to your pipe’s prolem area. Finally, jets of hot steam are used to cure it into place. You’ll eventually notice that the new lining has molded into all of the pipe’s cracks and leaks.

Pull-in Place

Some homeowners find that the cracks and gaps in their pipes are rather large. In this case, it’s best to go with the pull-in place method. This strategy calls for the use of steam that will be used to fix the material into place. The installer then pulls the epoxy-saturated liner into the area of the pipe that needs to be repaired. This requires two access points–one to feed the liner into and the other to pull the liner through. The installer will then use air to open the sleeve and then hold it against the pipe’s inner walls until it is completely dry.

If you live in Altamonte Springs and are experiencing problems with your pipes, it’s important to remember that there are several options when it comes to relining a pipe. And each of the above options leaves behind a seamless and smooth finished product. The method you choose will depend on your specific needs.

Call Now

X