Vacuum/Air Testing

Air-Loc® Pressure Testing Systems

airloc-pressureThe Cherne Air-Loc® Low Pressure Air-Testing System has been successfully used for testing sewer pipe installations for over 40 years. This method of testing pipelines had proven to be the fastest, most economical and accurate method of testing pipe. It allows you to perform tests as prescribed by ASTM C 828, C 924, and F 1417.

View Data Sheet

Air-Loc® Conversion Kits

airloc-conversionAir-Loc® Conversion Kit Features:

  • Converts Muni-Ball® plugs to air test plugs
  • Available for line acceptance and/or leak location tests

Equipped with:

  • Colored discs coded to hose connections
  • Conversion set up instructions

View Data Sheet

Air-Loc® Manhole Testers

airloc-manholeAir-Loc® manhole testers provide the most effi cient, accurate, and cost-effective method of testing new, existing, and rehabilitated manholes, per ASTM C 1244.

Vacuum testing identifi es infi ltration and exfi ltration problems by creating a vacuum in a manhole and then monitoring a gauge for vacuum loss. Less expensive and faster than water testing, the Air-Loc® manhole testers´ remote-infl ation and monitoring system keeps users away from the “danger zone.”

View Data Sheet

Air-Loc® Joint Testers

airloc-jointFast, safe, and easy to use, a five-second test determines joint integrity. Cherne´s Air-Loc® Joint Tester is designed to test large-diameter, installed, pre-cast concrete pipe as described in ASTM C1103.

Ready to test with water or air straight from Cherne´s factory-no modifi cations are needed-the Air-Loc® Joint Tester also allows you to pre-test before backfilling. Capable of testing to 15 PSI air or 50 psi water.

View Data Sheet